WPLN4182A IMPRESTM Single-Unit Charger
Smart Energy Systems
IMPRES™ Chargers
Through the use of advanced charging algorithms and automatic reconditioning
features, the IMPRESTM Smart Energy System ensures maximum
talk-time and optimized battery cycle life. This smart energy system automatically
reconditions IMPRESTM batteries based on actual usage, keeping
them in peak condition. Talk-time and cycle life are optimized and the
need for manual maintenance programs is eliminated. Its advanced conditioning
features allow batteries to be safely left on the charger for
extended periods of time without incurring the damaging heat build-up
which can decrease battery cycle life. In addition, batteries left in the
charger are kept fully charged so they are always ready when needed.
This rapid-rate, tri-chemistry charging system will also charge compatible
non-IMPRESTM batteries and supports multiple radio platforms.
WPLN4182A IMPRESTM Single-Unit Charger, 120 Volt - US
WPLN4183A IMPRESTM Single-Unit Charger, 240 Volt - UK
WPLN4184A IMPRESTM Single-Unit Charger, 220 Volt - Euro
WPLN4187A IMPRESTM Multi-Unit Charger, 120 Volt - US
WPLN4188A IMPRESTM Multi-Unit Charger, 240 Volt - UK
WPLN4189A IMPRESTM Multi-Unit Charger, 220 Volt - Euro
IMPRES™ Multi-Unit Chargers with Display Modules
Charger Display Modules provide powerful, “real time” analyzing
information for IMPRES batteries, including current charge status,
battery mAh, and voltage. Readout displays battery kit number, serial
number and chemistry and the time remaining to complete the charge
for NiCd and NiMH batteries. 120 Volt.
WPLN4192A IMPRESTM Multi-Unit Charger with Display Modules
NLN7967A Wall Mount for Multi-Unit Charger
IMPRES™ Individual Charger Display Module
This module is compatible with the standard IMPRES™ Multi-Unit
Chargers WPLN4187A, WPLN4188A and WPLN4189A. Up to 6
modules can be used per charger, one for each charging pocket.
Includes detailed installation instructions. 120 Volt.
RLN5382A Charger Display Module for IMPRES Multi-Unit
Charger Version 1.3 or Later.
Note: Display Modules compatible with Multi-Unit Charger version 1.2 or earlier require
a software flash update. Version number is located on label on the bottom of the
IMPRES™ Multi-Unit charger. If no version is shown, it is earlier than version 1.2.
Version 1.2 will appear as V1.20, 1.3 will appear as V1.30, etc.
IMPRESTM Multi-Unit Charger
with Display Modules
Multi-Unit Charger
Single-Unit Charger
Batteries left in the
charger are kept
fully charged so
they are always
ready when needed

Produk Lainnya